Unlimited applications, Long range
control
Six (6)
channel wireless control system
|
Portable Transmitter:
- Rugged Handheld Aluminum Enclosure
- 2-Watt Radio Transmitter
- 9 VDC Battery
- 8” Whip Antenna
- Belt Clip
|
- Supply Power: 9 VDC alkaline battery
- XMIT Current: 600 mA
- STBY Current: 1 mA
|
Base Receiver
- 6 Output Receiver
- 15-Watt Power Supply (110 VAC to 240 VAC
Input,
12 VDC Output)
- NEMA 4X Enclosure
- 42” High-gain Antenna
- Right-angle Antenna Mount
- 25’ Coaxial Cable w/ BNC Connectors
|
- Supply Power: 12 VDC
- (15 W power supply included)
- Output Current: 1 amp per output
- STBY Current: 30 mA
|
|
.
|
2
Miles ( 3 km )
■
Application dossier
Optional extended range up to 10 Miles (16Km)
Specifications
|
Operating
Voltage: |
12VDC/ 110-220VAc |
|
Operating
Temperature: |
-4° to +140° F (-20° to +60° C) |
|
Number of Codes: |
64000
codes, factory preset
16 BIT Digital |
|
Compliance: |
FCC CFR part 15.247, 95
sub E |
|
Transmission Power |
per FCC Part 15.249, 50mV/m @ 3m |
|
Carrier
Frequency |
27 MHz, industrial band
Free |
|
Current Transmitter |
Standby 0.1mA, transmitting
600mA |
|
Current
Receiver |
Standby
70 mA, operation, 150mA
|
|
Data Input
TX |
Dry contact N/O |
|
Relay Output |
1 Amp max, 30V max
Class 2 pilot duty |
|
Antenna Impedance |
50 Ohms
|
|
Dimensions: |
11.5"H x 8.5"W x
4"D (240 x 140 x 100
mm) |
|
Weight |
6
lb.
(3.4 Kg) each |
|
Enclosure NEMA4 |
IP65 Fiber
, wall or pole mount |
|
| |
Transmitter &
Receiver easy to install components: # 971215
1 Portable Transmitter
1
Base Receiver pre-wired,
relay output 10A, pilot duty
1 Antenna 42 inch Base Omni 5 dBi with PL259 connector
1 NEMA 4 IP65 Fiber Enclosure for wall or pole
mount
Instructions, installation &
wiring diagram,
|
|
The 971215 system is designed for outdoor/indoor
industrial wireless controls applications. The
transmitter has an output power of 2 watts @ 26.995 MHz.
The potential range is approximately 2 miles* and, with
proper antenna application, is not limited to line of
sight.
Operation
Operation is simple: select the receiver
output number you wish to activate, enter it on
the keypad and press the “ON” key. The
transmitter will immediately send an “ON”
transmission to the receiver, changing the state
of the selected receiver output from 0 VDC to 12
VDC @ 1 Amp. The receiver output will then be
used to activate the attached external 12VDC
relay. Immediately after pressing the “OFF” key,
the transmitter will send an“OFF” transmission
to the receiver, changing the state of the
selected output from 12 VDC to 0 VDC,
deactivating the attached external relay.
. |
|
Home
Shopping Cart