|
Industrial Wireless Radio Controls Modules
With Smart Programmable Controller
Performance
■ 1 Mile
(2.km) line-of-sight
938432 ant.
■ 3 Miles (5 km) line-of-sight 938433 ant.
■ Optional long range 5 Miles ( 8 km )
■ Input Dry isolated contact N/O
■ Relay output 10 Amp 240V/30V
Installation features
■ Operation license-free 433MHz ISM band
■ Easy installation,
■ Panel mount or clip onto DIN-35mm
rail |
. |
■
Features:
Monitoring and Control
Program up to 31 Clock Timers
30 Timers, 30 Counters
Logic functions
HMI Text Display
Included USB Program Interface
■
Controller specifications
■
Wireless specifications |
.
|
Operation |
Transmitter |
Receiver |
Continuous:
Factory Set; input and output
status display |
Close switch
Open switch |
Relay ON
Relay OFF |
93PLC4
Four (4) Channel Transmitter
and Receiver Set
|
|
|
System with Battery Charger and UPS
Specifications:
AC input range: 90 - 264VAC
Output 1: Load output
voltage: 12Vdc
Current range: 0 - 2.9 Amp
Output 2: Battery output
voltage: 13.8Vdc
Charging current: 1.0 Amp
934012UPS Module Charges the
battery,
Alarm signal for AC Ok and Battery Low
Battery low cut off/ reverse
protection
Protection: shortcut/ over
load / over voltage |
Typical 12Ah
battery may
provide 2 day backup
Battery not included
|
|
|
| Supply power |
12 VDC @
400 mA |
|
Inputs |
N/O Normally
Open, digital dry contact |
| Transmitter power |
per
FCC Part 15.249,
50mV/m @ 3m |
| Transmission |
Digital Encoded
Gaussian_frequency-shift_keying |
|
Channels |
16 addresses per system
GFSK |
|
Input Wiring |
Din Terminals,
Dry Contact |
| Response |
Loop 500 msec
|
| Weight |
0.8 lb (0.40kg)
each unit |
| Dimensions |
4.50 x 3.50 x 3.25
in. /
(114.30 x 88.90 x 86.75 mm) |
|
Specifications Digital Receiver
|
| Supply power |
12 VDC @
300 mA |
|
Output |
Relay SPST contact
6.Amp, 30V/240vac
Class 2 pilot duty |
| Frequency |
433 MHz •
License free Industrial ISM band |
|
Configuration |
DIP switch factory
preset |
|
Compliance |
FCC CFR part 15.247, 95 sub E |
| Wiring |
Components
mounted on 35mm DIN rail |
| Antenna Z |
50 Ohm SMA RF connector |
| Ambient temp |
14° to 140° F (-10° to 60°
C) |
| DIN Rail |
IP22, UL94-5VA, DIN mount 35mm
or panel mount |
Optional Enclosure NEMA 4
■ Fiberglass enclosure Clear
■ Pole or wall mount ready
■ Screw hinged cover, with
■ Aluminum internal sub panel
■ UL/cUL NEMA/CSA 4
■ UL #E345005
■
DIMENSIONS
|
|
DISCLAIMER:
Radio control equipment
in not to be used in life safety.
Radio Installations shall be
performed by a certified professional. |
|
■
Applications:
Industrial Monitoring,
Pump control,
Monitor remote
instruments, sensors,
Lighting,
Packing and mobile system, SCADA,
Factory process control,
Generators. Remote alarms.
Solar, Wire replacement
Antenna Selection (
TWO are required )
|
 |
938433
Yagi antenna
12 E
14 dBi 5 Mile+
Length: 43", Weight:
3.lb
with 10 ft coax cable and
connector |
 |
938455,
5
E Yagi Antenna
Gain: 9 dBi 3 Mile+
433 MHz, Rating:
150 Watts
Impedance 50 ohms
N terminal
Vertical beam 55 degrees -
Horizontal beam 60 degrees
With N female termination
Base Length: 32", Weight:
4.0lb |
|
|
 |
938432 Yagi antenna 3 E
7 dBi 1 Mile+
Length: 18", Weight:
1.lb
with 10 ft coax cable and connector |
|
 |
Omni directional base antenna 938450
Gain: 5 dBi,
2 Mile+
433 MHz, Rating:
100 Watts
Impedance 50 ohms
N terminal
Vertical beam 45 degrees
With N female termination
Length: 34", Weight:
3.0lb
10 ft coax cable and connector |
|
|
938092 |
938092
14" Omni Antenna
3 dBi 1500ft
line of sight
10ft coax cable SMA |
|
|
938091 |
938091
6" Omni Antenna
0 dBi Short range
5ft coax cable SMA |
|
Add Accessories:
|
Contactors |
933020
Miniature Contactor
20A, 3 Pole,
12VDC Coil
2HP
@240V, 7.5HP @460V
1HP @120V, 4
KW@ 220V
20Amp AC-1, 12Amp. AC-3
1 N.O. Aux.,
Dimension: 1.7 x 2.5 x 2.3 in
(45 x 64 x 58 mm)
Surface or DIN rail mountable
. |
|
|
|
|
